-
-
Remove resin hopper by unscrewing the bolt and dump all clean resin into Clear resin bucket
-
-
-
1 coffee can or 500 grams of clear resin
-
1 teaspoon or 2.5 grams of colored resin
-
Combine the colors in a mixing container and shake and mix appropriately. You want the colored resin to be distributed evenly throughout the clear polypropylene.
-
-
-
Remove the hopper and dump all contents into the bucket labeled “TYE DYE”
-
-
-
Extrude all the Dyna-Purge in the hopper by repeatedly pressing "circle" and the <- buttons
-
-
-
After every 1-2 extrudes, open the Nozzle Protection Door and remove the extruded plastic from the Nozzle using the knife. Be careful! The plastic may still be hot!
-
-
-
After the Dyna-Purge is finished, add about a ½ coffee can of clear resin to the hopper
-
-
-
Extrude the clear resin until it no longer has any color by repeating step #7.
-
Remember to clean the extruded plastic from the nozzle
-
-
-
When the plastic is finally clear, go into the “Setup” mode by pressing and holding the (HAND) button for longer than 3 seconds, then move PLASTICIZING UNIT back to operating position
-
Almost done!
Finish Line