Engel Color Changing Guide

Close shut-off gate on the hopper and remove the hopper

Dump all resin into the bucket labeled “Tye Dye”

Replace hopper onto machine and open the hopper gate

Mix your color resin with clear resin

1 coffee can of clear resin (Approximately 500g)

1 teaspoon of colored resin (Approximately 2.5g)

MIX THOROUGHLY. It is often useful to use an additional container to ensure the color is well dispersed.

Dump the mixture into the hopper and begin your parts run. NOTE: It may take several parts to begin noticing color change. This is normal

After your run is finished....

Close the hopper shut-off gate

Remove the hopper and dump all contents into the bucket labeled “TYE DYE”

Replace the hopper and re-open the hopper gate

Dump about ½ coffee can of Dyna-purge into the hopper

Retract the Nozzle by turning the NOZZLE Switch to the BACK position and place the wooden block onto the bushing

Turn the NOZZLE Switch to the FORWARD position until the Nozzle is pushing firmly against the wooden block and then turn the INJECTION Switch to the FEED position to fill the Nozzle with the Dyna-Purge

Retract the Nozzle and turn the INJECTION Switch to the INJECT position and extrude the Dyna-Purge from the nozzle

Repeat until all the Dyna-Purge in the hopper has been extruded

Be sure to clean the extruded Dyna-Purge!

After the Dyna-Purge is finished, add about a ½ coffee can of clear resin to the hopper

Extrude the clear resin until it no longer has any color

Move Nozzle back to operating position