-
-
Insert wisdom here.
-
-
-
Click on the icon in the bottom toolbar
-
-
-
In the Pop-up window, you can choose your printer, the material (resin type), and layer thickness (resolution). Make your adjustments and then click APPLY in the window.
-
-
-
Upload your STL by going to FILE, then OPEN
-
-
-
While in PreForm, make any adjustments to the model, such as rotate, scale, add supports, etc.
-
-
-
Click Send to Printer. (It will re-cap the settings)
-
-
-
Upload the job
-
-
-
Make sure the printer has: a: A clean build platform, b: A Tank, c: A resin cartridge
-
-
-
Upon confirming the above, tap PRINT NOW on the printer’s touch screen. (This will give you a warning to check to make sure that the cartridge vent is open and that the build platform is clean)
-
-
-
Press the button on the printer to confirm. (This will begin your print. It will take a few minutes for the resin tank to reach operating temperature.)
-
-
-
Insert wisdom here.
-
-
-
Insert wisdom here.
-
-
-
Insert wisdom here.
-
-
-
Insert wisdom here.
-
-
-
Wake up the wash station by pressing the selector dial. Highlight OPEN and press the selector dial.
-
-
-
Load the build platform onto the fixture
-
-
-
Select START and press the selector dial
-
-
-
Insert wisdom here.
-
-
-
Secure the build platform into the jig next to the wash station
-
-
-
Remove the part from the build platform using the scrapper
-
-
-
Insert wisdom here.
-
-
-
Close the door and use the selector dial to highlight START. Press the selector dial to begin curing
-