Introduction
Tools
Parts
No parts specified.
-
-
Make sure that OVENS are ON
-
Make sure that PLATENS are ON
-
Index the Master Clamp Frame (MCF) into the oven by turning the INDEX MCF on
-
-
-
After die is secure, close the safety gate then press the INDEX MCF button to “off” and move the clamp system to its original
-
-
-
The protective film can melt and drip onto the ovens
-
-
-
NOTE: there are registration lines to assist in correct placement
-
-
-
Ovens, platens, air, and Vac Pump ON & #1 BOTTOM VACUUM FORM set as the sequence.
-
Once it does, exit to MAIN MENU
-
-
-
Some key settings that may need timing adjustment:
-
a. Heating
-
b. Forming
-
c. Fan Delay
-
(NOTE: These settings are in seconds. Additionally, if the use of the fan is necessary, make sure the FANS button is ON)
-
-
-
To begin full job cycle, simultaneously press both START buttons a second time.
-
-
-
After the machine finishes the job, it is safe to remove the thermoformed part. It is a little warm, but not hot and therefore is safe to touch immediately
-
-
-
Go to SETUP menu and press the MCF INDEX button to move the clamp system away from the platen
-